Inventor General

Reply
Active Member
narzinski04
Posts: 7
Registered: ‎01-25-2012
Message 1 of 2 (85 Views)

rebuild/update error

85 Views, 1 Replies
05-14-2012 08:17 AM

I have a parameters only part which drives the parts in an assembly.  When I change the parameters and go back into the assembly I am getting an error.  I can accept the error and drag the parts around and they snap into place, which ends the error.  It works, but isn't very appealing to the eye.  Is there any way to fix this?

using inventor 2011

 

Thanks,

Nick

Valued Mentor
Rich.O.3d
Posts: 509
Registered: ‎08-19-2008
Message 2 of 2 (60 Views)

Re: rebuild/update error

05-14-2012 03:29 PM in reply to: narzinski04

adaptive parts and assemblies built with mates dont play nice

 

I would use skeleton modeling

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube