Inventor General

Reply
Distinguished Contributor
signmeup
Posts: 162
Registered: ‎10-18-2007
Message 11 of 11 (83 Views)

Re: inv 2012 isometric view when exiting sketch mode

01-16-2012 01:27 AM in reply to: andy

"When users tried to Extrude or Revolve while in a completely plan view, they did could not tell what to select."

 

good grief. where was the sanity check?

 

I can't tell what to select when the view I'm looking at whizzes away and I'm left looking at the whole sketch.

 

Try working with big sketches. One point is that you have to exit the sketch every time you save so this "helpful" change means

1. exit sketch

2. save

3. edit sketch

4. press F5 to restore previous view

5. carry on working on sketch

Product Design Suite 2014, HP Z400 12Gb, Nvidia Quadro 2000

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube