Inventor General

Reply
Active Member
reply2.vibh
Posts: 7
Registered: ‎04-17-2013
Message 1 of 4 (273 Views)

internal tube design problem

273 Views, 3 Replies
04-17-2013 08:30 AM

hi

 

I was trying to create Aircraft pitot tube using inventor and got the problem of internal tube designing in the connector section. Please see the attached files.

 

I am having problem designig the internal part of the end connector section where the internal tube  from the probe goes up bends and connects to a tube with end connector via an accumulator. (as shown in the  picture attached - Pitot.tube_abnormal.procedures-1_A300-600_Prunep.55)

 

please help me give sme suggestion

 

Vishal

*Expert Elite*
JDMather
Posts: 26,161
Registered: ‎04-20-2006
Message 2 of 4 (263 Views)

Re: internal tube design problem

04-17-2013 08:36 AM in reply to: reply2.vibh

Looks like Sweep should do it.

Can you attach the file(s) here?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
reply2.vibh
Posts: 7
Registered: ‎04-17-2013
Message 3 of 4 (254 Views)

Re: internal tube design problem

04-17-2013 08:40 AM in reply to: JDMather
Hello,

How could sweep help do an internal design specially when outer casing in
planer and the internal in circular /..




With Regards*

Vishal Bhatnagar*
Active Member
reply2.vibh
Posts: 7
Registered: ‎04-17-2013
Message 4 of 4 (247 Views)

Re: internal tube design problem

04-17-2013 08:47 AM in reply to: JDMather

Hello,

 

How can sweep help in this ??

 

could u upload a tutorial or so about this particular design ??

 

please fine the files attached in my original post as well as the reference file below (some how it got removed)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube