Inventor General

Reply
Active Member
Posts: 8
Registered: ‎06-13-2006
Message 1 of 2 (123 Views)

iPart Creation in Sheet Metal and Placing in Assembly.

123 Views, 1 Replies
11-28-2012 07:01 AM

Dear Autodesk Team,

 

I have created the Sheet Metal part wtih negative flange value. Ipart is creating the parts. but unable to use in assembly

 

Please guide.

 

*** Note : is it permissible to input value as NEGATIVE ***

 

Regards

 

Nasrullah Baig Mirza,
Mechanical Design Engineer,
*Expert Elite*
karthur1
Posts: 4,047
Registered: ‎04-27-2005
Message 2 of 2 (103 Views)

Re: iPart Creation in Sheet Metal and Placing in Assembly.

11-29-2012 06:36 AM in reply to: mirzanasrullah

What is the "negative flange values"?  What are you trying to accomplish with that?

 

Picture or parts would help.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube