I am trying to place a 5mm chamfer along edge so as it meets the cylinder....i cannot get it to work on this model but on an exact other model i can place a 5mm chamfer...am i missing something here
Inventor 2013/Inventor 2014
Go to Solution.
The question is; you have two different distances, and somehow, Inventor has issues split/merge the face between these two distances when you apply chanfer (between extrusion and revolve).
Check the attached part.
Did you find this reply helpful ? If so, use the Accept as Solution or Kudos - Thank you!
Thank you Carlos
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.