Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
If you have a broken circle, IV will only give you a partial centre mark, typically 3 legs. Hover your cursor over the end of the leg that doesn't appear and drag it out. It will snap to where the circle should be, matching the length of the other legs.
If you have large radii, IV7 pre SP1 did not create centre marks. After installing SP1 a very small mark is created, you might have to zoom in to see it. You will have to drag the legs of the centre mark out as beforementioned.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")