break out views are shifted only in doughter vievs

[Anonymous]

Hallo dear Inventor users!
My problem is in making break out views(drawing was made from assembly
file),
please help me!!!
I have base view, projected view from base view,section view
of proected one. And I want to create break out view on my sectioned view.
I create a sketch, associated with my sectioned view, apply dimentions to
it,
project geometry, tie my sketch to it with dimentions. then I finish sketch
and begin
to create break out view.I select sectioned view,my sketch become
highlighted and show
a distanse ( I try all of 4 methods to show distanse). Click OK-sketch is
dissappered,
anotation dimentions are left-but not create break out view,altho in
browther appered
+break out view!!!.Latter I understood that my sketh is shifted.I try to
make a fix
constrain-the same result.And this shifteng space is changing whan I move
view!
The most interesting-at base and projected view break out command works
perfectly!!!
I use Inventor R6 SP2
please help me to understand what I am doing not correct! my head is already
broken,
I am in dead end!!!

Always yours Maxim,mechanic of "Craneservise"

[Anonymous]

Try this. Get the sketch that you want. Now delete all projected lines
from the sketch and use fix constraints to fully define the sketch. I had
the same problem and narrowed it down to projected line. You project the
lines of the full view. Then you make a break out view and the lines you
created are not in the view to project. I don't know if it will clean up
the daughter views but it might make the whole thing more stable.

Kathy Johnson

[Anonymous]

I have tryed to use project lines and fix constraint - the same result.Most
interesting thing that all works (project lines or fix) without sketch
shifting in basic and projected views.And shifting of sketch does not depend
either there are breck out views on parent views!!!

[Anonymous]

Max

I have removed your duplicate post. Posting the same thing over again isn't
necessary, your original post is still here, and if people can answer it
they will.

--
Kent Keller
http://www.MyMcad.com/KWiK/Mcad.htm

Assistant Moderator
Autodesk Discussion Forum Moderator Program

"max" wrote in message
news:323AE65DC1D50719709559D84E270A50@in.WebX.maYIadrTaRb...
> Hallo dear Inventor users!
> My problem is in making break out views(drawing was made from assembly
> file),
> please help me!!!