Inventor General

Reply
*Adams, Brad
Message 1 of 1 (17 Views)

bend extents lines get turned on after changes in model

17 Views, 0 Replies
11-20-2002 02:00 AM
Does anybody else see this happen? I made a
sheetmetal angle and created a flat. I then created an IDW and place a view
of the flat pattern. I dimension everything out, everything is ok (no bend
extent lines on the flat.) I close out the IDW. I desided to make the sheetmetal
angle longer, so I make the changes in the IPT and save the file. Now I open up
the IDW and the bend extent lines are now onin the flat. I turn the bend extents
off and everything is fine. If I leave the IDW open and make a change to the IPT
the bend extents stay off. However it seems that if I close the IDW and make a
change to the IPT then reopen the IDW the bend extent lines are on again for the
flat.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube