Inventor General

Valued Contributor
Posts: 76
Registered: ‎04-27-2007
Message 1 of 2 (112 Views)

ansi pipe nipples

112 Views, 1 Replies
11-21-2013 12:20 PM

Is it only me or is there a complete lack of threaded pipe nipples (long and close) in content center?



*Expert Elite*
Posts: 2,839
Registered: ‎04-06-2010
Message 2 of 2 (110 Views)

Re: ansi pipe nipples

11-21-2013 12:23 PM in reply to: dave.deane

It's not you.


We created all of ours as iparts and published them.  Luckily we already had most of the iparts from our pre-tube & pipe days.  What's nice is that you can create the families you need for one material, then just copy them and modify the tables for any other materials you need.


A sample....





Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor