Inventor General

Reply
*Expert Elite*
mrattray
Posts: 2,210
Registered: ‎09-13-2011
Message 11 of 12 (105 Views)

Re: Yet another annoying message

12-13-2012 10:36 AM in reply to: jletcher

"iLogicVb.UpdateWhenDone = True" sets a flag that tells Inventor to update when it's done. It doesn't matter where it goes because it wont act on it until it's finished running everything anyways.

If I had used "InventorVb.DocumentUpdate()", then you would be correct, because this line causes Inventor to stop and update immediately.

 

Mike (not Matt) Rattray

*Pro
jletcher
Posts: 1,857
Registered: ‎05-18-2011
Message 12 of 12 (95 Views)

Re: Yet another annoying message

12-13-2012 10:48 AM in reply to: mrattray

Yeah I did know the rule just thought it reads from top to bottom no matter what unless you tell it to go back to it..

 

I did program a long time ago so things have changed a bit and I have not been following.

 

I am now into it and learning Curtis has helped me out so much I feel I owe him dinner lol...


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube