Heelo guys, can anyone help me with a little issue, I have an assembly which has components mated to a radial surface, I need to locate the center of a round slot against an axis, I have X Y coordinates, how can I constrain that part to those X Y coordinates? Thanks in advance!!.
Attached is a picture of the assembly.
I would use Assembly Constraints instead.
Pattern Workpoint (or other logical feature in the shaft part).
Component Pattern in the assembly.
Attach your assembly here if you can't figure it out.
I think there is a similar example in this document
If I understand your issue correctly, I have had more luck using this command when it comes to situations like yours.
...I have had more luck ...
I prefer logic.
The OP needs to clarify the problem statement through active discussion.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.