Inventor General

Reply
*Expert Elite*
blair
Posts: 3,629
Registered: ‎11-13-2006
Message 11 of 13 (200 Views)

Re: Weldment

10-28-2010 08:59 AM in reply to: ijc

You will probably have to do a Split-Face on the riser pipe. This will give a funny result at the points on the riser pipe.

 

Your Split-Face line will start at the end-point of the cope of the Riser pipe.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 PDSU / Sim Mech 2015 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 335.23
SpacePilot Pro 3.17.7, 6.17., 4.11
Distinguished Contributor ijc
Distinguished Contributor
ijc
Posts: 127
Registered: ‎07-03-2010
Message 12 of 13 (184 Views)

Re: Weldment

10-28-2010 02:18 PM in reply to: blair

Thanks Blair...IJC

New Member
eih5
Posts: 1
Registered: ‎05-28-2011
Message 13 of 13 (63 Views)

Re: Weldment

11-17-2012 04:52 PM in reply to: ijc

Hi,

Did you ever figure this out?

I am dealing with exactly the same problem, putting weldments on two pipes of same diameter.  I tried to use Split-Face but couln't get this to work. Help would be very much appreciated.

 

Einar

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube