Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am trying to dimension a ring in an .idw that has a chord cut off it.
Because of this, it is not a full circle and I can only get the radius value
for this dimension. I know why it is doing this, but is there any way I can
toggle to a diameter style dimension? I realize I could probably show a
linear dim across the quad's, but I'd rather show acircular type dimension.
Right Click while dragging the dimension and pick diameter.
"A J Anthony" wrote in message
news:93570CB7DB7A465975540534E102C11F@in.WebX.maYIadrTaRb...
> Hi All:
>
> I am trying to dimension a ring in an .idw that has a chord cut off it.
> Because of this, it is not a full circle and I can only get the radius
value
> for this dimension. I know why it is doing this, but is there any way I
can
> toggle to a diameter style dimension? I realize I could probably show a
> linear dim across the quad's, but I'd rather show acircular type
dimension.
>
> TIA
>
> Andre
>
>
Right click was one of my first thoughts but I guess I wasn't holding my
tongue right 🙂
A
"Byron Newton" wrote in message
news:4055D36874D29175BA61B641D36A859F@in.WebX.maYIadrTaRb...
> Right Click while dragging the dimension and pick diameter.
>
Howdy,
If you right click before actually placing the dimension, you can choose
Dimension Type and pick Diameter.
Amos
"A J Anthony" wrote in message
news:93570CB7DB7A465975540534E102C11F@in.WebX.maYIadrTaRb...
> Hi All:
>
> I am trying to dimension a ring in an .idw that has a chord cut off it.
> Because of this, it is not a full circle and I can only get the radius
value
> for this dimension. I know why it is doing this, but is there any way I
can
> toggle to a diameter style dimension? I realize I could probably show a
> linear dim across the quad's, but I'd rather show acircular type
dimension.
>
> TIA
>
> Andre
>
>
