Inventor General

Valued Contributor
Posts: 77
Registered: ‎10-23-2003
Message 1 of 1 (34 Views)

Tapped hole conversion problem from MDT6

34 Views, 0 Replies
11-04-2002 05:23 PM
Hi.....I'm designing a new machine which has a few legacy parts from MDT6 (originally MDT5).....I've noticed a problem when converting MDT6 parts which have tapped holes....The part translates fine, but initially there is no standard specified in the hole dialog box.....To correct this you can simply select the standard you need - but it's a bit of a pain to select every tapped hole in every convered part.......A picture is worth a 1000 words, so see the file in the CF.....Unzip it, open it and create an idw........Then try to spot the thread lines on the 3 tapped holes........Cheers.....Sean

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor