Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Sweep - Trimming and discarding faces error!!

3 REPLIES 3
SOLVED
Reply
Message 1 of 4
LiamHanlon
1041 Views, 3 Replies

Sweep - Trimming and discarding faces error!!

Hi all,

 

I'm trying to sweep six circles along 6 3d sketches however I recieve the 'The attempted operation had problems trimming and discarding faces. Try again with different outputs.

 

I have been suffering with the above error message and i am at my wits end. I've tried tracing the the geometry, played dot to dot joining up the points but to no avail. Some sweeps work and others dont.

 

Any help would be greatly appreciated

 

Thanks

3 REPLIES 3
Message 2 of 4
CCarreiras
in reply to: LiamHanlon

Hi!

 

 

In Sweep tool, if you change to parallel it works!

 

1.png

 

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!



Regards.
CCarreiras
Message 3 of 4
LiamHanlon
in reply to: CCarreiras

Thanks very much Carlos

Message 4 of 4
glenn-chun
in reply to: LiamHanlon

Hello OOBean,

 

Thanks for reporting this issue.  We have logged DID 1506198 in our database.

 

Glenn

Autodesk, Inc.

 



Glenn Chun
Sr. Principal Engineer

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report