Inventor General

Distinguished Contributor
Posts: 187
Registered: ‎03-25-2009
Message 1 of 1 (83 Views)

Sweep Problem

83 Views, 0 Replies
05-16-2012 05:20 AM

I could use a fresh pair of eyes on this. I'm looking to get rid of that little step & make the cut look continuous. Any suggestions regarding the easiest way to accomplish this would be appreciated. (See attached.)

Inventor Pro 2012
Vault Pro 2012

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor