Hello,
I have used a few times 'Stress analysis' before. Today I discovered it is disabled. I applied a software update (SP1, build 222), after which I could run a Stress analysis again. However, Inventor crashed soon, and after restarting it, Stress analysis is disabled again. In 'Add-In Manager' the 'Simulation: Stress analysis' is shown as 'Automatic/Loaded'.
Any hints what to check or do?
Thank you very much
Daniel
(Inventor 2014)
UPDATE: I have unchecked the 'Load Automatically' option for this module, quit Inventor, started it again, loaded the module and now it seems to work. I don't know yet for how long...
UPDATE2: well I could start a Stress analysis, but everything is disabled there, I can not create a simulation for example.
Can you please provide me with the following two diagnostics reports:
Microsoft Digit Report
Invneotr Diagnostics Report
I have attached 2 PDFs to assist you if needed.
Please post your results or private message them to me.
Thank you.