Inventor General

Reply
Distinguished Contributor
drguitarum2005
Posts: 196
Registered: ‎10-08-2012
Message 1 of 3 (151 Views)
Accepted Solution

Split Face Open Loop Error

151 Views, 2 Replies
12-16-2013 02:18 PM

I am attempting to split a face so I have a good area to apply a load in simulation and 3/4 of the areas split just fine but I CANNOT get the 4th area to split! This is all just projected geometry but left and right are symmetrical so I can't figure out why the L side works but not the R side...

 

Any ideas?

Distinguished Mentor
ccarreiras
Posts: 668
Registered: ‎02-04-2010
Message 2 of 3 (115 Views)

Re: Split Face Open Loop Error

12-17-2013 03:26 AM in reply to: drguitarum2005

Hi!

 

I Can't tell you why it does't work, but the trick is to know several ways to achieve the result.

 

I split the last area with the help of a surface... and the final result will be the one you want.

 

Part in attach, check it!

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

Regards.
CarlosC

Autodesk Inventor 2014 Certified Professional
Autodesk Factory Design Suite Ultimate 2015
Windows 7 64Bit
Distinguished Contributor
drguitarum2005
Posts: 196
Registered: ‎10-08-2012
Message 3 of 3 (106 Views)

Re: Split Face Open Loop Error

12-17-2013 06:13 AM in reply to: ccarreiras

Thanks for the info! I was able to do the same but I also, at the same time, found out why there was a problem. There are multiple points at the bottom that aren't connected but because its reference geometry, they can't be connected. I couldn't fix it so the 3D model must be weird but I was also able to mirror the good one over, within the sketch, and split it that way as well. Thanks!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube