Inventor General

New Member
Posts: 1
Registered: ‎08-05-2011
Message 1 of 2 (149 Views)

Shrink wrap a different position rep

149 Views, 1 Replies
08-05-2011 01:44 PM

I would like to shrink wrap a sub assembly in two different position reps. It seems to me like you can only shrink wrap while in the Master position rep. Is there a way to shrink wrap in a different position rep?

Posts: 5
Registered: ‎07-27-2011
Message 2 of 2 (128 Views)

Re: Shrink wrap a different position rep

08-07-2011 10:44 PM in reply to: devlybbert

Try the steps below:

1. Create Position Rep(new and activate position---Pos1/Pos2,select the position constraint then override,check on Suppresion=Enable,and input value)

2. Activate Pos1 or Pos2

3. Shrinkwrap

4. New Assembly->place Shrinkwrap file (using LOD->New Substitute->select part file)


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor