Inventor General

Reply
*Jeem
Message 1 of 3 (52 Views)

Same old problems with hole notes

52 Views, 2 Replies
11-05-2002 07:03 AM
I would like to use hole notes on the side view of a hole, either in section
view or projected, but the leader makes an arc or does not point at the hole
at all. I have always had this problem, is this a known problem?
*Jeem
Message 2 of 3 (52 Views)

Re: Same old problems with hole notes

11-05-2002 07:30 AM in reply to: *Jeem
Another problem is with tolerances on hole notes, deviation puts a + for
both units!

Where should I report, problems like this?
*McConnell, Cory
Message 3 of 3 (52 Views)

Re:

11-05-2002 07:37 AM in reply to: *Jeem
I ran into the same thing - you have to enter your tolerance units.

--
Cory McConnell
BJ Pipeline Inspection

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube