Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Roller Ghain - Double pitch

6 REPLIES 6
Reply
Message 1 of 7
ScottSwens
366 Views, 6 Replies

Roller Ghain - Double pitch

I am using the Roller Cain generator to design a chain drive. I wish to use ASME B29.3 Double-Pitch Power Transmission Roller Chain #2050. The generator says the pitch is 1.125.

 

If I look up the same chain from US Tsubaki, they are giving me a pitch of 1.250.

 

Whos is correct?

 

I am using Inventor 2013.

 

thanks

6 REPLIES 6
Message 2 of 7
mrattray
in reply to: ScottSwens

I use #2050 chain daily. Pitch is 1.250".
In fact, here is my purchase specs out of my ERP system for 2052 chain in case it helps you:
PP-CH-2052-D3-05
BLM CHAIN #2052-D3 @ 5" CENTERS
>Carrier Roller Chain
>Double pitch roller chain with oversize rollers
>D3 attachments on 5" centers
> 1.250" pitch
> Roller dia .750 /19.05mm
> Roller width .375 / 9.525mm
> Pin dia .200 / 5.08mm
> Plate height .594" / 15.0876mm
> Plate thickness 0.079"
> Maxium Allowable loads 970 LBS
> Average Ultimate strength 6,620 LBS
> Tensile strength 6100 LBS
Mike (not Matt) Rattray

Message 3 of 7
blair
in reply to: ScottSwens

I would go with the data from the chain supplier that you will be using.


Inventor 2020, In-Cad, Simulation Mechanical

Just insert the picture rather than attaching it as a file
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Delta Tau Chi ΔΤΧ

Message 4 of 7
mrattray
in reply to: ScottSwens

In fact, I'm curious where they get 1.125 from, because 2040 is 1.0"...
Mike (not Matt) Rattray

Message 5 of 7
ScottSwens
in reply to: mrattray

that makes two of us.

Message 6 of 7
jletcher
in reply to: ScottSwens

That is why I don't use it or content center parts.

 

 Burn me one time never again cost me lots...

Message 7 of 7
dan_inv09
in reply to: jletcher

Ditto

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report