Inventor General

Reply
*Sam
Message 1 of 2 (56 Views)

Part vs sheetmetal

56 Views, 1 Replies
11-16-2002 11:52 PM
Is there anyway to convert a sheet metal part into a regular part?

Is there any difference except fot the menu it defaults to?
*Keller, Kent
Message 2 of 2 (56 Views)

Re: Part vs sheetmetal

11-17-2002 12:17 AM in reply to: *Sam
The biggest difference is the menus, and SM adds a few
parameters....Thickness act. To switch it just to etc. Applications
dropdown, and change it from Sheet Metal to Modeling.

--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"Sam" wrote in message
news:F104AFC59EDDC932B7A8483105E8DF92@in.WebX.maYIadrTaRb...
> Is there anyway to convert a sheet metal part into a regular part?
>
> Is there any difference except fot the menu it defaults to?
>
>

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube