Inventor General

Reply
New Member
Posts: 1
Registered: ‎09-12-2012
Message 1 of 2 (150 Views)

Part Configurations

150 Views, 1 Replies
09-12-2012 12:35 PM

Say I have a small rectangular part that appears once in a model.

 

Can I design the original part so it's fabricated in a strip of 10 parts - then place a "configuration" of the part in a model that only shows 1 of the 10 parts?

 

SW is my first tool - but I'm (happily) using Inventor at the moment. Thanks!

*Expert Elite*
Cadmanto
Posts: 3,068
Registered: ‎12-07-2011
Message 2 of 2 (142 Views)

Re: Part Configurations

09-12-2012 12:42 PM in reply to: jpoulette

Welcome to the forum.

In Inventor they call them factory and iparts.  Take a look at the attached link.

But yes it can be done.

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube