Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

PART TIME KEY IN AN IPART

2 REPLIES 2
Reply
Message 1 of 3
mark0ms
101 Views, 2 Replies

PART TIME KEY IN AN IPART

How do I set up a parameter in an iPart table so that it is a key for some parts, but not others created by the factory?
2 REPLIES 2
Message 2 of 3
Anonymous
in reply to: mark0ms

Don't think you can. you can however make it so it only has one value in that key when
needed.

--
Kent
Member of the Autodesk Discussion Forum Moderator Program


"mark0ms" wrote in message news:f129f09.-1@WebX.maYIadrTaRb...
> How do I set up a parameter in an iPart table so that it is a key for some parts, but
not others created by the factory?
Message 3 of 3
Anonymous
in reply to: mark0ms

yep..

--
Sean Dotson, PE
http://www.sdotson.com
Check the Inventor FAQ for most common questions
http://www.sdotson.com/faq.html
-----------------------------------------
"Kent Keller" wrote in message
news:ED22F0E2405295BDE62378AFFEBD0F00@in.WebX.maYIadrTaRb...
> Don't think you can. you can however make it so it only has one value in
that key when
> needed.
>
> --
> Kent
> Member of the Autodesk Discussion Forum Moderator Program
>
>
> "mark0ms" wrote in message
news:f129f09.-1@WebX.maYIadrTaRb...
> > How do I set up a parameter in an iPart table so that it is a key for
some parts, but
> not others created by the factory?
>
>

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report