Inventor General

Reply
Valued Contributor
Mark.Downes
Posts: 101
Registered: ‎11-18-2010
Message 1 of 1 (192 Views)

Oloid - using reference surface edges as guides

192 Views, 0 Replies
12-19-2012 03:50 AM

Hi,

 

This has been asked a few times and it’s one of those things that on the face of it sounds really easy. 

Humm, so where to start???

 

I have had a few goes at these using lofts, extrusions with guide curves, sheet metal loft in an assembly (4 or 6 parts welded together) etc… but nothing really looks correct with the methods I used.

 

Ok, back to basics looking though my surfacing tutorials from time gone by.  The good old Boundary Patch tool along with a guide surface for tangency seems to give the best results so far. I have been stuck in the “solid model methodology rut” when surfacing really is the quickest and easiest method. I think I will spend a bit of time re-learning the advantages of hybrid surface/sold modelling.

 

I hope this is of use to someone

Merry Christmas to all

 

Cheers

 

Mark

Inventor 2013

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube