Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
In rare cases, you need to set ACADSERVER in windows environment to the
server name... however, that is not normally needed. You do need to
share the Flexlm folder on the server, though.
Dennis Jeffrey
bplatosz wrote:
> Does anyone know what the environmental variable is that needs to be
> pointed to the flexlm license servers for Inventor R7?
>
> Thanks in advance...
> Bob-
>
--
Dennis Jeffrey
Advanced Solutions, Inc.
Phone 260-432-9695 x 233
http://www.advsolinc.com
Have you set up the Flex manager that came with IV 7 / MDT 2004? It
is buried very deep on CD no 2 F:\Bin\ACADFeui\support\nlm - the is the
setup. - Replace F with the letter of your CD drive.
I could not get
IV 7 to work until I installed the new one.
Have you set up the Flex manager that came with IV 7 / MDT 2004? It
is buried very deep on CD no 2 F:\Bin\ACADFeui\support\nlm - the is the
setup. - Replace F with the letter of your CD drive.
I could not get
IV 7 to work until I installed the new one.
Amazing, I was looking all over for a different method than licpath.lic and I was told it didn't exist. NOBODY could tell me ANYTHING about that variable. Good info, THX.
Amazing,
I was looking all over for a different method than licpath.lic and I was told
it didn't exist. NOBODY could tell me ANYTHING about that variable. Good info,
THX.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")