Inventor General

Reply
Valued Mentor
Rich.O.3d
Posts: 509
Registered: ‎08-19-2008
Message 11 of 11 (99 Views)

Re: My drawing hatch is so precise...

06-25-2012 03:15 PM in reply to: moretti999

First inventor converts the angle to radians then to fractional degrees then to decimal degrees, it then applies an analogous algorithm based on the colour of the 5th nearest star from earth multiplied by the deriviative of........

 

I get this too...it drives me nuts

 

Are you using a metric template, I am

I suspect that is where the issue comes from...inventor not quite knowing how to convert all the numbers properly so in the math that drives the auto hatch angle, there is a rounding issue.

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube