Inventor General

*Bruns, Bradley
Message 1 of 1 (77 Views)

Mechanical symbols explode when saving as dwg

77 Views, 0 Replies
11-06-2002 10:36 PM
When I save an IDW to DWG, the mechanical symbols (feature control frames,
datum targets, etc.) always explode. I know Acad does not support all these
symbols but Acad Mechanical does.
It there a way convert these symbols directly to the Acad Mechanical
equivalents? Currently I erase each one and replace them manually.

I'm not trying to gripe here, but this is yet another time waster and
headache that I get when converting to dwg.



You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor