Inventor General

Reply
Active Contributor
dexterdweller
Posts: 42
Registered: ‎02-18-2013
Message 1 of 3 (123 Views)
Accepted Solution

Manage ipart configurations inside assembly table

123 Views, 2 Replies
04-17-2013 11:39 AM

Basically I need to have 2 configurations of an assembly. These assemblies are identical except there is one part that will vary within them. What is the best method to take in doing this can be done in a table I would think but I need some guidance. Eventually I would like to be able to drive an assembly with multiple part configurations and suppressing and unsuppressing of parts from a table however this is my starting spot.

 

Any feed back is appreciated.

 

Thanks!

*Expert Elite*
Cadmanto
Posts: 3,175
Registered: ‎12-07-2011
Message 2 of 3 (109 Views)

Re: Manage ipart configurations inside assembly table

04-17-2013 01:46 PM in reply to: dexterdweller

Create your ipart factory.  Then insert it into your assembly.

Once in place then create the factory in the assembly.  In the table under the

component select the "Table replace" selection under the part.

This will allow you to toggle between each ipart within the table.

 

table.PNG

Hope this helps you.

 

check.PNGIf this solved your issue please mark this posting "Accept as Solution".

Or if you like something that was said and it was helpful, Kudoskudos.PNG are appreciated. Thanks!!!! :smileyvery-happy:

Inventor.PNG     vault.PNG

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

Active Contributor
dexterdweller
Posts: 42
Registered: ‎02-18-2013
Message 3 of 3 (105 Views)

Re: Manage ipart configurations inside assembly table

04-17-2013 02:13 PM in reply to: Cadmanto

Thanks thats what I was looking for!

 

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube