Inventor General

Reply
*Expert Elite*
Posts: 2,274
Registered: ‎12-12-2006
Message 11 of 11 (48 Views)

Re: Level of Detail (LOD) to show dotted lines?

06-06-2012 12:34 PM in reply to: mcgyvr

It's like if I were to say, "I was walking along and stepped on a banana peel and fell down." then you come along and post "Step on the banana peel."

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube