Inventor General

Posts: 18
Registered: ‎12-02-2002
Message 1 of 3 (71 Views)

Is a bulk conversion MDT ->> Inventor possible

71 Views, 2 Replies
11-07-2002 04:20 AM
Hi folks! does anybody have expierence with an "over night" migration from mdt6 to inv 5.3 (6)?
please let me know.
Distinguished Contributor
Posts: 387
Registered: ‎12-10-2003
Message 2 of 3 (71 Views)

Re: Is a bulk conversion MDT ->> Inventor possible

11-07-2002 10:36 PM in reply to: peter12
had one take 7 hrs to migrate it was a very large file all but two or three parts had problems. but all went fine
Posts: 18
Registered: ‎12-02-2002
Message 3 of 3 (71 Views)


11-08-2002 05:05 AM in reply to: peter12
ok, i will explain in detail!

does anybody have experiences in converting
3000 MDT-Files (1000 Assemblies) to x thsd
Inventor-Files with an automated conversion

best regards peter

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor