Inventor General

Active Contributor
Posts: 40
Registered: ‎01-24-2012
Message 1 of 3 (186 Views)

Inventor assembling

186 Views, 2 Replies
09-11-2012 10:59 PM



I need help with assembling parts which I highlighted in the picture. I tried varoius types of constrain but I cannot attach those parts, to have them bound together. Could you please advise me about technique I should use in this particular case. The rest of the clutch part I have done with the success




*Expert Elite*
Posts: 3,064
Registered: ‎12-07-2011
Message 2 of 3 (137 Views)

Re: Inventor assembling

09-12-2012 10:00 AM in reply to: leech10

Hi Peter,

I would try this command in the assemble tab, to see if it helps you.  Looks like you have some tangent constraints and

I find this command most useful in these situations.


Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

*Expert Elite*
Posts: 25,259
Registered: ‎04-20-2006
Message 3 of 3 (121 Views)

Re: Inventor assembling

09-12-2012 11:57 AM in reply to: leech10

Mate - Flush workplanes.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2014 Edu 64-bit

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor