Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Inventor Admin - Control which add-ins load on first run? Inventor 2011

2 REPLIES 2
Reply
Message 1 of 3
guyh
340 Views, 2 Replies

Inventor Admin - Control which add-ins load on first run? Inventor 2011

Hi,

 

Is there an easy way to ensure the Vault ribbon/addin loads within Inventor 2011?  

 

Thanks,

 

Guy

AutoCADM 2011 SP2
Inventor Pro 2011 SP2
2 REPLIES 2
Message 2 of 3
cbenner
in reply to: guyh

On the Add Ins manager screen, make sure that "Load Automatically" is checked.  The Add Ins will load at startup from then on.

 

I have noticed in the past, however, that a crash to desktop will sometimes change these settings and you will have to set them back up again.  Might want to take screen shot of your Add Ins setup and save it someplace, just in case.

Message 3 of 3
guyh
in reply to: cbenner

Appreciate the reply. I'm Ok with that side of things. My question likely wasn't very clear. Following an install of Inventor I have it configured to load the company application options but the Vault add in isn't loaded or set to load automatically at this stage. I want to know if it's possible to ensure the add in will load on the first run of Inventor following an install.

Thanks,
Guy
AutoCADM 2011 SP2
Inventor Pro 2011 SP2

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report