Inventor General

Reply
Active Member
mariappan.u
Posts: 7
Registered: ‎08-26-2011
Message 1 of 2 (184 Views)

Inventor 2012 simulation engine

184 Views, 1 Replies
11-07-2011 07:48 PM

Hi all,

 

Can any one tell Autodesk inventor simulation 2012(stress analysis) follows which engine?(Ansys or Algor)

 

Thanks.

Employee
Posts: 635
Registered: ‎06-07-2007
Message 2 of 2 (158 Views)

Re: Inventor 2012 simulation engine

11-09-2011 09:45 AM in reply to: mariappan.u

Hi mariappan.u,

 

  In R2012 we use a solver based on PlassoTech technology.  It is capable of adaptive h-p meshing and solving.

 

Hope this helps,

 

Thanks, -Hugh



Hugh Henderson
Simulation QA Engineer
DLS

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube