Inventor General

Valued Contributor
Posts: 70
Registered: ‎03-26-2008
Message 1 of 2 (640 Views)
Accepted Solution

Ilogic Rule to change custom iproperty

640 Views, 1 Replies
12-11-2012 12:54 PM



I am after help on writing part of rule for ilogic,i need the rule to fill out a custom property with information for me


I have a part that has 2 parameters


  1. parameter 1 = Frontplanangle
  2. parameter 2 = Endplanangle

Custom property


iProperties.Value("Custom", "DESC2") =



I need the rule to examine both parameters and if both angles = 0 then DESC2 = ""
And if any parameter >0 then

iProperties.Value("Custom", "DESC2") = bevel/


*Expert Elite*
Posts: 2,572
Registered: ‎03-08-2006
Message 2 of 2 (634 Views)

Re: Ilogic Rule to change custom iproperty

12-11-2012 01:17 PM in reply to: dclunie

Hi dclunie,


Something along these lines should work:


If Frontplanangle = 0 And Endplanangle = 0 Then
iProperties.Value("Custom", "DESC2") = ""
ElseIf Frontplanangle > 0 Or Endplanangle > 0 
iProperties.Value("Custom", "DESC2") ="bevel/"
End If
MessageBox.Show("DESC2 = " & iProperties.Value("Custom", "DESC2"), "iLogic")

 I hope this helps.
Best of luck to you in all of your Inventor pursuits,

  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor