Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

IV6 Sketch Dimension Error

3 REPLIES 3
Reply
Message 1 of 4
Anonymous
87 Views, 3 Replies

IV6 Sketch Dimension Error

Please take a look at the file under the same topic in CF. The value of my
sketch dimension is not correct in regards to the actual value. I have no
idea how this happened. Has anyone else seen this?
3 REPLIES 3
Message 2 of 4
jmartzig
in reply to: Anonymous

i haven't looked at your post, but today in idw mode, i got a dimension that was 2.13". i knew that wasn't correct. exited the idw, opened it again, and dimmed again. it then gave me the correct dimension of 7.36". go figure? -Joe
Message 3 of 4
Anonymous
in reply to: Anonymous

This was in a .ipt, but yours is just as bad if not
worse.  The guys in the shop just love to hear it when we blame our
mistakes on the software.  The problem is they think it is just an
excuse.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
haven't
looked at your post, but today in idw mode, i got a dimension that was 2.13".
i knew that wasn't correct. exited the idw, opened it again, and dimmed again.
it then gave me the correct dimension of 7.36". go figure?
-Joe
Message 4 of 4
Anonymous
in reply to: Anonymous

Anyone have any thoughts on this?


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">

This was in a .ipt, but yours is just as bad if
not worse.  The guys in the shop just love to hear it when we blame our
mistakes on the software.  The problem is they think it is just an
excuse.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
haven't
looked at your post, but today in idw mode, i got a dimension that was
2.13". i knew that wasn't correct. exited the idw, opened it again, and
dimmed again. it then gave me the correct dimension of 7.36". go figure?
-Joe

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report