Inventor General

Reply
Active Member
bodich
Posts: 9
Registered: ‎09-16-2012
Message 1 of 2 (176 Views)

How to make attached part Adaptive?

176 Views, 1 Replies
12-01-2012 07:28 AM

When I create part .ipt directly in assembly .iam, I can make it adaptive. I'm doing the projection of geometry. Detail goes adaptive. Geometry appears as a link.

But if I put in the assembly finished parts or remove part created in the assembly, and then insert it back, the adaptability of parts did not get to create. Then the projection geometry inserts usual nonadaptive geometry without reference.

Can I make a finished part adaptive, without creating a component at the place in this assembly?

Thank you!

Valued Mentor
IgorMir
Posts: 481
Registered: ‎08-02-2003
Message 2 of 2 (162 Views)

Re: How to make attached part Adaptive?

12-01-2012 05:39 PM in reply to: bodich

Try to open a part and un-check Adaptively Used in Assembly box in Document Settings-->Modeling.

Please see the attached picture for clarity.

Regards,

Igor.

Web: www.meqc.com.au

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube