Inventor General

Active Member
Posts: 9
Registered: ‎09-16-2012
Message 1 of 2 (172 Views)

How to make attached part Adaptive?

172 Views, 1 Replies
12-01-2012 07:28 AM

When I create part .ipt directly in assembly .iam, I can make it adaptive. I'm doing the projection of geometry. Detail goes adaptive. Geometry appears as a link.

But if I put in the assembly finished parts or remove part created in the assembly, and then insert it back, the adaptability of parts did not get to create. Then the projection geometry inserts usual nonadaptive geometry without reference.

Can I make a finished part adaptive, without creating a component at the place in this assembly?

Thank you!

Valued Mentor
Posts: 457
Registered: ‎08-02-2003
Message 2 of 2 (158 Views)

Re: How to make attached part Adaptive?

12-01-2012 05:39 PM in reply to: bodich

Try to open a part and un-check Adaptively Used in Assembly box in Document Settings-->Modeling.

Please see the attached picture for clarity.




You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor