Thank you for submitting an error report and providing your feedback.
Please verify that you have installed Service Pack 1 for Vault 2013. The message you received indicates that the issue is addressed by Vault 2013 SP1.
You can download Vault 2013 SP1 from the following location:
Please note that there have been 3 Hotfixes released post SP1. I recommend that you install these as well.
Please let me know if still see this issue after installing these updates.
I told you not to load it did I not?
Sorry for your issues please go vote for Don't Add anything...
I hear your frustration.... but from my experience, Inventor 2013 is just as stable as 2012 or any other prior release. There are about 12 others here that use Inventor daily in a production environment and we dont have these kinds of problems.
We all are using SP1.1 update 1. Have not loaded Update 2 on any of the machines.
Windows 7 x64 -12 GB Ram
Intel i7-930 @ 3.60ghz
nVidia GTS 250 -1GB (Driver 301.42)
INV Pro R2013, SP1.1 (update1)
Vault Basic 2013
In your image autodesk is asking you to install a VAULT hotfix, not an inventor one... any idea why?
Just asking because i also installed update 2, but didn't check for updates on vault since we only use the vault for the content center bit...
(haven't ran into the problems you described so far, fingers crossed...)
Good point! I never even noticed. That was the reply from my second CER I submitted, not sure why it's for Vault, we are not using Vault at my current client, so I don't even have it enabled.
Thanks for your reply, problem we're not using Vault. Well not yet. We are planning on installing it within the next week or so.
So I guess my question is, why would I still need to install an update for a program we are not using?
Trust me Jim, I tried to warn them, but they were already using it and 2014 has yet to come out. I didn't want to have to deal with the hopping back and forth between their 2013 and my 2012 until I felt 2014 was stable enough to use.
2013 has been fine for the most part up until I loaded Update #2 and now since I've uninstalled that update everything is running back as it normally did.
I haven't had an assembly crash yet when changing files out, and a I can create Break Out Views at will again.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.