I have a 14 gage sheet metal part that follows the profile in the attached picture. 7/8" legs with a 1/16" offset. Because it's 14 gage, the contour flange won't create it. I need it to be able to be turned in to a flat pattern so that I may export it to a .dxf. Is there another way to make this that will allow me to flat pattern it? I have a couple of pieces like this where the offset is very slim, so I am looking for a way to do all of them like this.
Solved! Go to Solution.
That profile is just incorrect. Its not made like that in real life unless its a stamping operation which Inventor cannot properly define the flat pattern for.
How is this part fabricated?
Model the 2 faces then use "bend" to connect them if press braked.
Attached is an example that might give you a hint. I didn't see any information on what version of Inventor you're using, but hopefully you can open an Inventor 2010 file (that's the oldest version I have Installed these days.)
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Inventor 2013, forgot that.
It's a stamping procedure. You're right, I was going about it the wrong way and drew it incorrectly.
Curtis, that example is excellent, thank you for your help!
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register