Hello Rob,
Another go, my first post got ruined for some reason.
I tried it in Design Accelerator - Spur Gear generator. Diametral Pitch - I
was able to enter 0.2 as a minimal value, not 1/8. However it's possible to
specify other values - 20 deg for Pressure Angle and 15 deg for Helix Angle.
Design Accelerator uses approximation of teeth.
I can send you the gear model by email if needed, send me your contact on
lukasDOTpolanskyATautodesk.com.
Thanks and Regards,
Lukas Polansky
DAcc QA Engineer
Autodesk
"Marvin Lee Aday" wrote in message
news:4988656@discussion.autodesk.com...
Looking for a model or source for a Helix Gear. Specifically, 1/8 CP, 20
Deg. PA, 15 Deg. Helix.
Any help would be appreciated.
Thanks,
Rob