Inventor General

Reply
Valued Mentor
GSE_Dan_A
Posts: 297
Registered: ‎10-06-2011
Message 1 of 2 (103 Views)

FEA Capable to simulate a PL on a pipe?

103 Views, 1 Replies
01-18-2013 08:17 AM

Hello all,


I am wondering if the FEA in Inventor 2013 is capable of simulating a pipe under a point load and at what point the pipe fails.  Its a simple 2in dia pipe supported by a vertical tube with a load of 'X' centered on the pipe.

 

Thanks in advance.

GSE Consultants Inc.
Windsor, ON. Canada
*Expert Elite*
cwhetten
Posts: 1,051
Registered: ‎09-03-2008
Message 2 of 2 (93 Views)

Re: FEA Capable to simulate a PL on a pipe?

01-18-2013 09:14 AM in reply to: GSE_Dan_A

Yes, it can do this.  But it depends on what you mean by failure.  Inventor will perform a linear analysis, so any result with stresses above the yield stress will be meaningless.  But if by failure you mean "exceeds the yield limit", then Inventor will be of use.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube