Inventor General

Reply
Active Contributor
VeronicaSmith5891
Posts: 42
Registered: ‎05-07-2009
Message 1 of 4 (355 Views)
Accepted Solution

Extrude all Projected Geometry automatically?

355 Views, 3 Replies
02-07-2013 10:36 AM

I have looked thru the forum and didn't see this question anywhere.  Many times I have to make mounting holes on large assemblies that have a lot of holes to project and extrude.  

 

Is it possible for the Extrude command to pick all Projected Geometry automatically?  If it looked only specifically for only projected geometry?  It would save so much time instead of having to pick every single projected geometry hole to extrude.

 

Thanks!

*Expert Elite*
Curtis_Waguespack
Posts: 2,775
Registered: ‎03-08-2006
Message 2 of 4 (352 Views)

Re: Extrude all Projected Geometry automatically?

02-07-2013 10:44 AM in reply to: VeronicaSmith5891

Hi VeronicaSmith5891,

 

Here is a simple iLogic rule that I use to do this:

http://inventortrenches.blogspot.com/2012/03/ilogic-to-select-all-of-closed-profiles.html

 

I just set any profiles that I don't want to extrude to use construction lines, so that Inventor won't pick them up.

 

Here's another good tip for this sort of thing:

http://inthemachine-autodesk.typepad.com/blog/2010/08/embrace-the-intersect.html

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Active Contributor
IS200
Posts: 34
Registered: ‎06-06-2011
Message 3 of 4 (327 Views)

Re: Extrude all Projected Geometry automatically?

02-07-2013 02:27 PM in reply to: VeronicaSmith5891

We project in from the assembly, select all, change to construction lines and centre points, then run the hole tool.

This auto-selects all the centre points and voila! Done. If you need to control the size of the holes you can cross link parameters between the part and assembly.

Active Contributor
VeronicaSmith5891
Posts: 42
Registered: ‎05-07-2009
Message 4 of 4 (276 Views)

Re: Extrude all Projected Geometry automatically?

02-14-2013 09:35 AM in reply to: IS200

This worked perfect!  Thanks so much!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube