Inventor General

New Member
Posts: 1
Registered: ‎11-11-2012
Message 1 of 2 (276 Views)

Extrude a horizontal small cylinder across a vertical big cylinder

276 Views, 1 Replies
11-11-2012 09:51 AM

Dear guys,

In inventor 2013 I want to extrude  a horizontal circle on surface of a bigger vertical hollow cylinder. but waht i did it enters into cylinder, and i only want to extrude it on external surface. I would be greatfull for anyone who can help me.the file is attached.

*Expert Elite*
Posts: 25,253
Registered: ‎04-20-2006
Message 2 of 2 (272 Views)

Re: Extrude a horizontal small cylinder across a vertical big cylinder

11-11-2012 11:13 AM in reply to: tally11

In general you should add holes near the end of a design.

Model the part similar to the way ti would be manufactured.

You could extrude and cut away again, but I recommend simply starting over and do the part correctly from the beginning.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2014 Edu 64-bit

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor