Dynamic simulation publish to inventor studio

[dejan_nedelkovski]

Hi!

I wanna simulate a car engine, so i need springs for the valves. So in Dynamic Simulation i make them, and they work properly. So when i publish them in inventor studio, all the motions works fine ( the springs forses work ) , but the springs are gone. They just disappear. 

So how can i make them visible while i am in Inventor Studio ?

[JDMather · Accepted solution]

http://forums.autodesk.com/t5/Autodesk-Inventor/Springs/td-p/3142268

Unfortunately those springs are just graphical representations of spring forces.

It sure would be nice (and I don't understand why it would be particularly difficult) if Inventor could automatically create those as ipts for you with an animated length parameter.