Community
I have a logo in curves inserted into a titleblock.
It looks perfect.
When I export to PDF it looks like this:
It's like in Illustrator when you specify whther the line is on the inside or outside of the curve, but I don't know how to control this in Inventor. I've tried changing the line thickness and all that but I've not had any success.
Another shot of the curves:
Any ideas?
Inventor 2013
I put the line thickness down to 0.001 and it shows what's happening. All teh lines are breaking up. Why would it do this when they are fine in teh drawing?
Try changing this setting: Tools>Document Setting>Drawing>Use Bitmap>Off-Line
Try increasing the Bitmap Res as well.
Inventor 2020, In-Cad, Simulation Mechanical
Just insert the picture rather than attaching it as a file
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Delta Tau Chi ΔΤΧ
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")