Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Dimensioning in an .idw

2 REPLIES 2
Reply
Message 1 of 3
Adams.trenton
228 Views, 2 Replies

Dimensioning in an .idw

I need to know how to dimension to a theoretical sharp on bent flanges.  In an .idw it wont snap to the sharp and when a schetch is created for one it does not dimension between them only one or the other.  Any help would be appreciated.  Thank you

2 REPLIES 2
Message 2 of 3
japike
in reply to: Adams.trenton

On a flange that is more or less than 90 degrees, pick your first edge, right click and select intersection, then select the second edge.

Peace,
Jeff
Inventor 2022
Message 3 of 3
Cadmanto
in reply to: Adams.trenton

See if this thread helps you out.

 

http://forums.autodesk.com/t5/Autodesk-Inventor/DIMENSION-TO-VIRTUAL-SHARPS/m-p/3276285#M421834

Best Regards,
Scott McFadden
(Colossians 3:23-25)


Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report