Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Too bad you can't unfold a loft in SM. You can
unfold a cylinder but if it was possible to unfold a loft rolled cones and
folded cones would be a snap (just like coding for it, right <G>).
<Gd&h)
I had issues with this recently, and found out that
IV needs to see exactly straight edges along the bendlines, but a loft creates
most often slightly curved edges. Having straight edges is one of the basic
demands for a unfold.
Regards, -- Leo Laimer Maschinen-
und Fertigungstechnik A-4820 Bad Ischl - Austria
Too bad you can't unfold a loft in SM. You can
unfold a cylinder but if it was possible to unfold a loft rolled cones and
folded cones would be a snap (just like coding for it, right <G>).
<Gd&h)
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")