I am creating a 3 section shaft using the Design Accelerator. Each section of the shaft has a keyway. I am able to add a plain keyway to the 1st and 3rd sections but I am not able to add the same keyway to the center of the second section. (Compare the two attachments). To center the keyway on a shaft, the only option I have is to Add Keyway Grove. For sections 1 and 3, I had the option that said Plain Keyway Grove which allows you to place the correct shaped keyway groove referencing the end of the shaft. How can I have the middle keyway to look like the keyways on the end sections?
For each of the keyways I am able to select the length of the keyway but it is not allowing me to change the depth value of the keyway. The depth value is grayed out and it is not the correct depth according to the drawings I am using as a guide. Any suggestions on how to change the depth if it does not match the drawings? See