Inventor General

Active Member
Posts: 9
Registered: ‎03-23-2012
Message 1 of 2 (47 Views)

Coordinate system Revit and Autocad

47 Views, 1 Replies
04-23-2012 07:52 AM

Hi all


I have a question, when i am creating a coordination system in Autocad and after that i want to export it in Revit, there is aways difference between the two reference points, the one from the Autocad file and the Project base point in Revit.

I managed to mach them by moving the autocad file, but i don't think this is the correct way of doing it.


I will be grateful if you could help me with this.


Distinguished Mentor
Posts: 988
Registered: ‎07-26-2005
Message 2 of 2 (40 Views)

Re: Coordinate system Revit and Autocad

04-23-2012 08:06 AM in reply to: Toni_n_k

might have better luck in either the AutoCAD forums;


or the Revit forums;

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor